ES SERIES ELECTRIC HUMIDIFIER
The “ES” Series Electric Humidifier from PURE Humidifier Company is loaded with features and options. All you need is water, electricity, and a sanitary drain—the humidifier does the rest.
–
Available Models
The “ES” model works with standard water and uses a Tri-Probe assembly to maintain the water level. The “ESDDR” model is for use with Deionized, Demineralized or Reverse Osmosis water. It utilizes a stainless steel float-operated fill valve to maintain the water level and a stainless steel float-operated low water cut-off switch.
Ease of Maintenance
The unique side-entry heater assembly provides a large clean out access section without disturbing the cover or injection tube system’s steam supply piping.
Capacity range up to 306 lbs/hr with single units. Multiple humidifiers in a Master/Drone configuration allow for an unlimited system design.
INTAC® Microprocessor
The INTAC® microprocessor comes factory-mounted on the control panel door and provides industry-leading features. It comes loaded with features such as a vacuum fluorescent display, WATTCycle heater control, time-to-clean messages, on-screen “HELP” menus, full networking and BAS communications ports.
Control
Available with basic On/Off control (+/- 5%), Time Cycle Modulation for close tolerance applications (+/- 3-4% RH), or SCR modulation for superior controllability (+/- 1-2% RH).
Choose from straight injection tubes, Fast-Pac multiple injection tube assembly, or the Insty-Pac for short dissipation applications. Area humidification can be achieved using a remote-mounted Blower Pack assembly.
Standard ES Features
- 304 stainless steel construction
- Tri-Probe level controller
- Adjustable surface water flusher
- Motorized drain valve with brass body
- User-adjustable automatic drain system
- Seasonal End of Use drain system
- Manual reset over-temperature switch
- 80 watt per square inch incoloy immersion heaters
- INTAC® Microprocessor
Standard ESDDR Features
- 304 stainless steel construction
- Stainless steel float-operated fill valve
- Stainless steel overflow stand pipe
- Stainless steel manual ball valve drain
- Manual reset over-temperature switch
- 80 watt per square inch incoloy immersion heaters
- INTAC® Microprocessor
Optional Features
- Factory-mounted control panel
- NEMA 4 weather-tight control panel
- Control panel door lock
- Door interlock safety switch
- Support legs
- Wall brackets
- Factory-insulated reservoir
- Freeze protection
- Stand-by water temperature sensing
- Blower Pack for area humidification
- Variable Air Volume control
- Outdoor air temperature sensing
- Drain tempering kit
- Remote INTAC® microprocessor controller
- Outdoor Enclosure